Team:British Columbia/modeling results
From 2010.igem.org
Line 8: | Line 8: | ||
<h3>Simulations Results</h3><p> | <h3>Simulations Results</h3><p> | ||
<h4>The Binary Outcome</h4><br/> | <h4>The Binary Outcome</h4><br/> | ||
- | <b> | + | <b>Death</b><br/> |
<img src="https://static.igem.org/mediawiki/2010/d/d2/UBC_main_death.jpg" width="600"><br/><br></br> | <img src="https://static.igem.org/mediawiki/2010/d/d2/UBC_main_death.jpg" width="600"><br/><br></br> | ||
+ | <p><b>Figure 1: </b>The simulated behavior of the biofilm and phage populations over 1200 mins (20 hrs). The percent of the total biofilm poopulation remaining after phage introduction (blue) sharply declines at 400 min. This coincides with the sharp increase of the percent of the biofilm population infected by phage (green). The phage population (here, represented by the P-factor) peaks shortly after 400 mins. These features suggest that the accumulation of phage particles in the biofilm between 0 and 400 min triggers mass host cell lysis leading to the destruction of the biofilm by 900 min (15 hrs).</p> | ||
<img src="https://static.igem.org/mediawiki/2010/6/63/UBC_main_death_sub.jpg" width="600"><br/><br></br> | <img src="https://static.igem.org/mediawiki/2010/6/63/UBC_main_death_sub.jpg" width="600"><br/><br></br> | ||
- | <b>( | + | <p><b>Figure 2: </b>The dynamics of the extracellular concentrations of AIP (purple) and DspB (red) over 1200 mins (20 hrs). The maximum level of AIP concentration and the activation threshold level are indicated by the upper and lower dashed lines, respectively. AIP concentration is shown to steadily decrease over time, but does not fall below the threshold level during the 1200 mins. DspB concentration rises rapidly at 400 min, coinciding with decrease in biofilm population and increase in phage population (indicated in Figure 1), and then peaks at 600 min when the biofilm population is substantially reduced.</p> |
+ | <b>Survival</b><br/> | ||
<img src="https://static.igem.org/mediawiki/2010/7/71/UBC_main_survival.jpg" width="600"><br/><br></br> | <img src="https://static.igem.org/mediawiki/2010/7/71/UBC_main_survival.jpg" width="600"><br/><br></br> | ||
<img src="https://static.igem.org/mediawiki/2010/5/57/UBC_main_survival_sub.jpg" width="600"><br/><br></br> | <img src="https://static.igem.org/mediawiki/2010/5/57/UBC_main_survival_sub.jpg" width="600"><br/><br></br> |
Revision as of 01:01, 25 October 2010
Simulations Results
The Binary Outcome
Death
Figure 1: The simulated behavior of the biofilm and phage populations over 1200 mins (20 hrs). The percent of the total biofilm poopulation remaining after phage introduction (blue) sharply declines at 400 min. This coincides with the sharp increase of the percent of the biofilm population infected by phage (green). The phage population (here, represented by the P-factor) peaks shortly after 400 mins. These features suggest that the accumulation of phage particles in the biofilm between 0 and 400 min triggers mass host cell lysis leading to the destruction of the biofilm by 900 min (15 hrs).
Figure 2: The dynamics of the extracellular concentrations of AIP (purple) and DspB (red) over 1200 mins (20 hrs). The maximum level of AIP concentration and the activation threshold level are indicated by the upper and lower dashed lines, respectively. AIP concentration is shown to steadily decrease over time, but does not fall below the threshold level during the 1200 mins. DspB concentration rises rapidly at 400 min, coinciding with decrease in biofilm population and increase in phage population (indicated in Figure 1), and then peaks at 600 min when the biofilm population is substantially reduced.
SurvivalSensitivity Analyses
Phage virulence is critical to successful biofilm dispersal
Half-life is not a main outcome-determining factor
DspB Makes Life Easier For the Phage