Revision as of 15:47, 5 August 2010 by Shethharsh08 (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Contents 1 Gel Electrophoresis for the Amplified Fragments of rocF 1.1 Aim 1.2 Materials and Protocol 1.3 Result 1.4 Discussion 1.5 Conclusion 1.6 Solution for the problem

Gel Electrophoresis for the Amplified Fragments of rocF

Aim

The aim of the experiment is to perform gel electrophoresis for all the 6 PCR reactions which took place yesterday 4th August, 2010 and thus confirm that all 6 PCR reactions were successful.

Materials and Protocol

Please refer to: Gel electrophoresis.

Result

• Lane 1: 1kb DNA ladder
• Lane 2: BioBrick compatible vector pSB1C3
• Lane 3: Pspac_oid promoter
• Lane 4: 1st fragment of rocF CDS
• Lane 5: 2nd fragment of rocF CDS
• Lane 6: 3rd fragment of rocF CDS
• Lane 7: Double Terminator
• Lane 8: 1kb DNA ladder

	Biobrick compatible vector pSB1C3	Pspac_oid pormoter	1st fragment of rocF CDS	2nd fragment of rocF CDS)	3rd fragment of rocF CDS	Double Terminator
44.0 µl/ml	19.9 µl/ml	25.0 µl/ml	30.8 µl/ml	10.0 µl/ml	44.2 µl/ml	9.2 µl/ml	39.7 µl/ml

Table 1: Nanodrop spectrophotometer experiment result. Table represents the amount of plasmid present in µl/ml quantity.

Discussion

We found bands in the lane 2, 3, 4, 5 and 6 showing the presence of plasmid in E. coli DH5α cells. The ideal concentration of DNA calculated using nanodrop experiment is 150 µg/ml but in the table 1, where all the values have been less than 150 µg/ml which shows that even though there is plasmid present in the cells but it is present in very low amount. Also while doing nanodrop experiment, we measured 260/280 nm ratio for all the samples came out to be between 2.0 to 2.4 approximately which shows that there is a high RNA contamination in the samples.

Conclusion

This experiment shows that there is plasmid present in the E. coli DH5α cells but they are present in a very low amount and having high RNA contamination possibly due to the following reasons:

1. P1 buffer which contains RNAse might be contaminated.
2. RNAse enzyme might have gotten inactive.

Solution for the problem

1. If P1 buffer of the Qiagen miniprep kit is contaminated, then use a different kit. We have Promega miniprep kit which will be used tomorrow.
2. If RNAse enzyme is inactive, then add extra RNAse into the P1 buffer. We would be adding 10 µl in the P1 buffer solution.