Latest revision as of 23:21, 27 October 2010

DNA Re-hydration

This protocol is used for re-hydration of DNA. We used this mainly for our newly arrived primers.

To begin, read the Oligonucleotide Specification Sheet to find the OD260 values and number of DNA bases for each primer/DNA.
Once those values are found, divide the (OD260 value) by (number of DNA bases x10).
Multiple the result by 1000
Divide 10 by the previous result, and multiple all by 100: the end result is the volume of primer DNA (in µl) required to prepare 100µl at 10pM concentration.
Rehydrate lyopholsed primers in 1ml sterile water
Remove the appropiate volume of rehydrated primer and add Pure Lab Distilled Water to make the solution up to 100 µl in total.

Please note:

Extra care must be taken when following this protocol, i.e. there must be NO contamination.
The newly arrived primer tubes have to be handled with extra caution, because they will be the main stocks which working stock solutions will be made from. Therefore, gloves have to be worn, as well as preventing any contamination. Water will be used in order to liquefy the primers and the water used will be from Pure Lab Distilled Water.

Figure 1 showing Pure Lab Distilled Water apparatus.

Go back to our Protocol List

@@ Line 19: / Line 19: @@
 # Divide 10 by the previous result, and multiple all by 100: the end result is the volume of primer DNA (in µl) required to prepare 100µl at 10pM concentration.
 # Rehydrate lyopholsed primers in 1ml sterile water
-# Add Pure Lab Distilled Water to make the solution up to 100 µl in total.
+# Remove the appropiate volume of rehydrated primer and add Pure Lab Distilled Water to make the solution up to 100 µl in total.
 Please note: