Team:Newcastle/Slide Preparation
From 2010.igem.org
(Difference between revisions)
(→Slide Preparation) |
(→Slide Preparation) |
||
Line 16: | Line 16: | ||
'''Go back to our [[Team:Newcastle/Protocol list|Protocol List]]''' | '''Go back to our [[Team:Newcastle/Protocol list|Protocol List]]''' | ||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
{{Team:Newcastle/footer}} | {{Team:Newcastle/footer}} |
Revision as of 14:27, 26 October 2010
![]() | |||||||||||||
|
Slide Preparation
- Grow overnight culture in 5 ml of LB broth, with appropriate antibiotics if required, at 37°C.
- Dilute the overnight culture to a ratio of 1:100 (overnight culture:LB with appropriate antibiotic ). Incubate at 37°C for 1 hour.
- Set up the following broths with different concentrations of IPTG in 5 ml of LB broth:
- 2mM IPTG
- 0.2mM IPTG
- 0.02mM IPTG
- Broth only
- Innoculate the broth containing the different concentrations of IPTG with the appropriate cultures and incubate at 37°C for two hours.
- Prepare the slides by pippeting 500 µl of 1.2% agarose. Gently place the coverslip over the slide.
- Wait for about 5 minutes for the agarose to harden. Remove the coverslip by gently sliding the coverslip horizontally from the slide. This is to ensure that agarose layer remains undisturbed.
- Transfer 200 µl of each sample to microfuge tubes and label accordingly. Add 0.5 µl of membrane dye to each sample.
- Place 0.5 µl of each sample in each well of the slide and label accordingly. Place a coverslip on top of the slide.
- The slide is now ready for microscopy.
Go back to our Protocol List
![]() ![]() ![]() ![]() |
![]() ![]() ![]() ![]() ![]() |