"
Team:Cambridge/Gibson/Protocol
From 2010.igem.org
(Difference between revisions)
(→Step 1: Design Primers) |
|||
| Line 6: | Line 6: | ||
==Step 1: Design Primers== | ==Step 1: Design Primers== | ||
{{:Team:Cambridge/Templates/RightImage|image=Cambridge-oligoface.jpg|caption=Designing Oligos Old-School}} | {{:Team:Cambridge/Templates/RightImage|image=Cambridge-oligoface.jpg|caption=Designing Oligos Old-School}} | ||
| - | + | ||
*If you wish to ligate two pieces of DNA using Gibson they must be altered so as to have 40bp of overlap at the point of ligation. | *If you wish to ligate two pieces of DNA using Gibson they must be altered so as to have 40bp of overlap at the point of ligation. | ||
| Line 14: | Line 14: | ||
==Step 2: Order Primers== | ==Step 2: Order Primers== | ||
| - | + | {{:Team:Cambridge/Templates/RightImage|image=Gibthon.png|caption=New and improved Gibthon oligo design}} | |
*This step can take a while, so Gibson Assembly requires some planning ahead | *This step can take a while, so Gibson Assembly requires some planning ahead | ||
Revision as of 20:32, 23 October 2010
Gibson Assembly: Protocols
The formal paper in nature describing Gibson Assembly can be found [http://www.nature.com/nmeth/journal/v6/n5/full/nmeth.1318.html here].
Step 1: Design Primers
Designing Oligos Old-School
- If you wish to ligate two pieces of DNA using Gibson they must be altered so as to have 40bp of overlap at the point of ligation.
- The standard way to do this is with PCR with specialised primers
- We have designed a tool to help you do this: [http://www.gibthon.org Gibthon]
Step 2: Order Primers
New and improved Gibthon oligo design
- This step can take a while, so Gibson Assembly requires some planning ahead
Phusion Polymerase
Step 3: PCR
PCR is a dark art, but we have found that these general principles have served us well over the summer.
| Step | Temp | Time |
| 1:Initial Melting | 98°C | 30s |
| 2:Melting | 98°C | 10s |
| 3:Annealing | Tm°C | 15s |
| 4:Elongation | 72 | 45s per kb DNA |
| 5:GoTo step 2 | 30 times | |
| 6:Final Elongation | 72°C | 7m30 |
| 7:Final Hold | 4°C | ∞ |
The Annealing Tm that should be used is the temperature of the main 20 or so bases of the primer (not including the flap), since the flap only begins to anneal after the first few cycles, by which point primer specificity is less of an issue.
Step 4: Gibson Assembly
- Prepare Master Mix
- Add DNA to be ligated and Master Mix in volumetric ratio 1:3
- Incubate for 1 hour at 50°C
e.g. If you were ligating two fragments (A and B) you could put:
| 2.5µl | fragment A |
| 2.5µl | fragment B |
| 15µl | Gibson Master Mix |
Step 5: Transformation
