Team:TU Delft/Modeling/pcaif-model

From 2010.igem.org

(Difference between revisions)
(pCaif Model: Induction through Limitation)
(pCaif Model: Induction through Limitation)
 
(One intermediate revision not shown)
Line 5: Line 5:
This model is an extension of the [https://2010.igem.org/Team:TU_Delft#page=Project/sensing sensing sub-project]
This model is an extension of the [https://2010.igem.org/Team:TU_Delft#page=Project/sensing sensing sub-project]
===Aim===
===Aim===
-
We implemented the pCaiF promotor to enable a metabolic switch from glucose to  hydrocarbons. As the complete BioBrick for hydrocarbon degradation is not available yet, we mimic the switch using the end product of the hydrocarbon degradation, lauric acid. The fatty acid degradation is under the control of fadR, which is like pCaiF under the control of crp-cAMP. To check the function of pCaiF a [[https://2010.igem.org/Team:TU_Delft#page=Project/sensing/results|series of experiments]] has been performed and a simple model is set-up to analyze the capabilities of the BioBrick.
+
We implemented the pCaiF promotor to enable a metabolic switch from glucose to  hydrocarbons. As the complete BioBrick for hydrocarbon degradation is not available yet, we mimic the switch using the end product of the hydrocarbon degradation, lauric acid. The fatty acid degradation is under the control of fadR, which is like pCaiF under the control of crp-cAMP. To check the function of pCaiF a [https://2010.igem.org/Team:TU_Delft#page=Project/sensing/results| series of experiments] has been performed and a simple model is set-up to analyze the capabilities of the BioBrick.
===Experimental Basis===
===Experimental Basis===
Line 14: Line 14:
''' 2g Glucose:'''  Glucose depletion is reached, but there is no alternative substrate at high concentration. The cells are expected to accumulate high cAMP amounts and try to increase the uptake capacities by high expression of alternative carbon source pathways.
''' 2g Glucose:'''  Glucose depletion is reached, but there is no alternative substrate at high concentration. The cells are expected to accumulate high cAMP amounts and try to increase the uptake capacities by high expression of alternative carbon source pathways.
-
''' 1g Glucose + 0.9g Lauric Acid:'''  Glucose depletion is reached fast, and there is an alternative substrate available. Lauric acid is consumed via beta oxidation that is under the control of fadR. We expect a switch and autoregulation behavior. When glucose is depleted, the genes for lauric acid degradation are expressed. For a short period of time, the carbon influx is very limiting, cAMP levels are high. Then the influx of lauric acid delivers carbon and energy, cAMP drops again, the protein production is reduced until an equilibrium is reached.
+
''' 1g Glucose + 5mM Lauric Acid:'''  Glucose depletion is reached fast, and there is an alternative substrate available. Lauric acid is consumed via beta oxidation that is under the control of fadR. We expect a switch and autoregulation behavior. When glucose is depleted, the genes for lauric acid degradation are expressed. For a short period of time, the carbon influx is very limiting, cAMP levels are high. Then the influx of lauric acid delivers carbon and energy, cAMP drops again, the protein production is reduced until an equilibrium is reached.
===Modeling Approach===
===Modeling Approach===
Line 96: Line 96:
[[Image:TUDelft_pCaif_2g.png|660px|center|thumb|Fig. 2: GFP and OD response in 2 g/L glucose minimal medium: Predicted vs. modeling results.]]  
[[Image:TUDelft_pCaif_2g.png|660px|center|thumb|Fig. 2: GFP and OD response in 2 g/L glucose minimal medium: Predicted vs. modeling results.]]  
-
'''1g/L glucose + 0.9 g/L lauric acid:'''
+
'''1g/L glucose + 5 mM lauric acid:'''
[[Image:TUDelft_pCaif_1g.png|660px|center|thumb|Fig. 3: GFP and OD response in 1 g/L glucose and 5 mM lauric acid minimal medium: Predicted vs. modeling results.]]
[[Image:TUDelft_pCaif_1g.png|660px|center|thumb|Fig. 3: GFP and OD response in 1 g/L glucose and 5 mM lauric acid minimal medium: Predicted vs. modeling results.]]

Latest revision as of 22:52, 27 October 2010

pCaif Model: Induction through Limitation

We would like to thank Aljoscha for helping us out with this model.

This model is an extension of the sensing sub-project

Aim

We implemented the pCaiF promotor to enable a metabolic switch from glucose to hydrocarbons. As the complete BioBrick for hydrocarbon degradation is not available yet, we mimic the switch using the end product of the hydrocarbon degradation, lauric acid. The fatty acid degradation is under the control of fadR, which is like pCaiF under the control of crp-cAMP. To check the function of pCaiF a series of experiments has been performed and a simple model is set-up to analyze the capabilities of the BioBrick.

Experimental Basis

Of special interest was a set of three experiments:

10g Glucose: Here, no glucose depletion is reached. The expression of genes under pCaiF control should be ‘off’.

2g Glucose: Glucose depletion is reached, but there is no alternative substrate at high concentration. The cells are expected to accumulate high cAMP amounts and try to increase the uptake capacities by high expression of alternative carbon source pathways.

1g Glucose + 5mM Lauric Acid: Glucose depletion is reached fast, and there is an alternative substrate available. Lauric acid is consumed via beta oxidation that is under the control of fadR. We expect a switch and autoregulation behavior. When glucose is depleted, the genes for lauric acid degradation are expressed. For a short period of time, the carbon influx is very limiting, cAMP levels are high. Then the influx of lauric acid delivers carbon and energy, cAMP drops again, the protein production is reduced until an equilibrium is reached.

Modeling Approach

From the discussion on the experiments, a set of hypothesis has been derived:

1. cAMP levels are coupled to the carbon influx: It is assumed that the concept of flux sensors as shown recently by Kotte et al., 2010 can be applied to ‘measure’ the flux for the two carbon degradation pathways. Kremling et. al. 2007 have shown that scrY that is also dependent on the transcription factor crp has a hyperbolic Hill relation (with n=6) to the EIIACrr ratio. Assuming that the that EIIACrr ratio is related to the cAMP levels, we used following relation between cAMP and the uptake flux qGlc:

TUDelft pCaifmodel 1.png

Comparably, a less ‘steep’ function was defined for cAMP levels in dependence of the lauric acid uptake:

TUDelft pCaifmodel 2.png

To combine the two levels, a multiplication is applied (if one flux operates at max rate, the cAMP should be zero, in case of two low fluxes the cAMP has to be high:

TUDelft pCaifmodel 3.png

Note that cAMP is basically modeled on a normalized scale 0-1. Clearly that is a strong simplification, but as no detailed intracellular data is available we take this relative scale.

2. Growth Stoichiometry: Yield, maximal uptake rates: The stoichiometric coefficients were taken from Lin et al. 2001 and adapted slightly to enable reaching our biomass concentrations:

TUDelft pCaifmodel 4.png

for lauric acid no value has been found so we made an assumption:

TUDelft pCaifmodel 5.png

The maximal uptake rate on glucose was determined by Lin et al. 2001:

TUDelft pCaifmodel 6.png

For lauric acid, the enzyme concentration is modeled – we had to assume some specific enzyme activity:

TUDelft pCaifmodel 7.png

The growth rate depends on the uptake of both substrates:

TUDelft pCaifmodel 8.png

As in some experiments nitrogen limitation is reached, growth is additionally dependent on the N availability:

TUDelft pCaifmodel 9.png

Again, this mechanism is simplifying – in the experiments saturation is observed at OD=0.45 (corresponding to about 0.13 gCDW/L).

3. Enzyme expression: The expression of the enzyme depends on the intracellular cAMP levels with a hyberbolic relationship (n=1.5):

TUDelft pCaifmodel 10.png

The parameters were chosen based on ‘good’ estimates derived Alon (2007).

There is dilution and degradation, the balance for the enzyme then reads:

TUDelft pCaifmodel 11.png

4. Measurement Model

The model state variables biomass concentration X and GFP levels (intracellular) are mapped on the experimental observations by:

OD = X/0.37 * 0.33

GFP = rGFP * GFPintra * X

The factor for OD/biomass was taken from Debreczeny and Davies. Because the wells were filled with 100 uL a correction for the shorter light pass is used (1/3 of the nominal volume). The response factor for GFP is estimated from parameter optimization.

Parameter fine tuning

With the experimental data in hand we were able to perform a parameter estimation based on the data of the three mentioned experiments.

Results

The reproduction of the experimental results is shown in fig. 1. Please note, that the same parameters are able to reproduce the different conditions.

10g/L glucose:

Fig. 1: GFP and OD response in 10 g/L glucose minimal medium: Predicted vs. modeling results.

2g/L glucose:

Fig. 2: GFP and OD response in 2 g/L glucose minimal medium: Predicted vs. modeling results.

1g/L glucose + 5 mM lauric acid:

Fig. 3: GFP and OD response in 1 g/L glucose and 5 mM lauric acid minimal medium: Predicted vs. modeling results.

Conclusions

The model helped us in keeping track of the possible mechanisms that could be ‘behind’ the data. It clearly shows, that a simple approach – taking assumptions of relations between concentrations and fluxes together with a simple enzyme expression model can explain the observed behavior under three conditions. It also clearly shows another property – the expression of the pathway enzymes are ‘auto-controlled’. If the protein levels drop, the flux will drop, cAMP rises and the expression will rise. Also, if there is too much enzyme, the cAMP levels will drop significantly, enzyme expression will stop, until a limiting situation is reached again. That finding surprised us, showing that a very simple, and very small BioBrick can do the job of protein level regulation.

References

  1. Kotte, O, Zaugg, J., Heinemann, M., Bacterial adaptation through distributed sensing of metabolic fluxes, Molecular Systems Biology, 6:355, 2010 doi:10.1038/msb.2010.10
  2. Kremling, A., Bettenbrock, K., Gilles, E.D., Analysis of global control of Escherichia coli carbohydrate uptake, BMC Systems Biology, 1:42, 2007 doi:10.1186/1752-0509-1-42
  3. Lin, H. Y., Mathiszik, B., Xu, B., Enfors, S.-O., Neubauer, P., Determination of the Maximum Specific Uptake Capacities for Glucose and Oxygen in Glucose-Limited Fed-Batch Cultivations of Escherichia coli, Biotechnology and Bioengineering, 73, 347-357, 2001
  4. Alon, U. (ed.), An Introduction to Systems Biology: Design Principles of Biological Circuits, CRC Press, 2007
  5. Debreczeny, M.P, Davies, E.T., Non-Invasive Biomass Monitor with Wide Linear Range, Manuscript text.