Team:Monash Australia/Modelling


Revision as of 13:32, 26 October 2010 by Ddbuckley (Talk | contribs)



Yang cycle

The three key enzymes we require are highlighted in the image, SAM synthase, ACC synthase and ACC oxidase. SAM synthase converts methionine into S-Adenosyl-L-Methionine (SAM), using ATP for an adensoyl group. The second step involves ACC synthase, which cleaves the amino butyrate from SAM, releasing 1-aminocyclopropane-1-carboxylic acid (ACC). Released ACC is then processed by ACC Oxidase which converts ACC to ethylene by cleaving the carboxylic acid off as carbon dioxide and its neighboring carbon with the amino group as cyanide gas. By using such a system to produce ethyene gas we can potentially reduce costs involved with current production methods by reducing temperature requirements by 30 fold.

Kinetic modelling of the ethylene generator

The program tinkercell was used to model the synthesis of ethylene in our e.coli cell. Where, in addition to the qualitative representation (figure 1) the program allowed, simulation of the model could be exercised inorder to measure the flux of metabolites – with respect to time - in the system given the input of values pertaining to substrate/enzyme concentration, and reaction rates were inputted. In addition to experimental data, with a model, theoretical data can be obtained using the model to extrapolate quantitative data corresponding to mRNA, protein and ethylene outputs under set parameters and assumptions in silico. As a result, using the given theoretical model outputs as a benchmark, manipulations to the parameters and assumptions set can be made in vitro/in vivo in order to achieve higher outputs in future studies of the 'ethylene generator'.

Figure 1: network diagram of the desired reactions in an 'E. coli' cell needed for ethylene production - created on Tinkercell

Aims of the Kinetic Modelling

-To determine the maximum output of ethylene

-To estimate HCN levels and assess potential damage to cell

-Start with a simple model and get more complex to more accurately predict ethylene production

Model 1

Introduction of Model 1

This model was designed to be the starting point of the our kinetic modelling. Therefore it was decided to begin with a realitivly simple construct.This uncomplicated system could then be used to obtain an ethylene output. This design comprised only of three enzymes and lacked the transcription and translation stages. The enzymes invloved were SAM synthetase, ACC synthase and ACC oxidase or EFE (ethylene forming enzyme). These enzymes were presnt at fixed concentrations (10, 100, 1000 and 3000 uM) and in the 1:1:1 ratio.. This ensured that the model was plain yet ultimately obtained a resonable yet simple ethylene output. Therefore with fixed enzyme concentrations the rate at which ethylene is produced depends on the Vmax of the specific enzymes.

This specific rate is defined by the Michaelis-Menton Equation

Rate =   -------------------------
             km + [substrate]

Assumptions for Model 1

- A 1:1:1 steady state of enzymes

- No production inhibition

-Substrates (ATP, L-Methionine etc) kept at a constant value due to homeostatic mecahnisms in E.coli

- The best value (km, kcat etc) was always chosen to ensure maxiumum yield of ethylene

Parameters and Values used

Met concentration - 150 uM

ATP concentration - 9600 uM

O2 concentration - 442 uM

SAMsynth Km(Met)- 92 uM

ACCsynth Km(AdoMet)- 37 uM

EFE Km(ACC)- 12 uM

SAMsynth turnover rate (kcat)- 1.5 per second

ACCsynth turnover rate (kcat)- 18 per second

EFE turnover rate (kcat) - 5.9 per second

Graphs and results

More to come

Model 2

Model 2 explores the more complicated version of our kinetic modelling. It aims to incorporate the transcription and translation rates of the cell into the final design. This calculation begins to become more difficult due to problomatic degredation,transcription and translation rates. However these values where obtained from the Elowitz repressorlator model. Of the many sources browsed it was determined that this source seemed to be the most accurate and hence its values were used. Therefore the constant production and degredation of mRNA and the three enzymes ultimately changes the final production of ethylene. Therefore this model is designed to produce a more accurate representation of the biological pathways occuring in the E.coli cell.

Elowitz Degradation Values

mRNA degradation rate - 0.00577 mRNA per second

Enzyme degradation rate - 0.001155 enzymes per second

Graphs and results

more to come

Construct --> mRNA --> enzymes (SAMsynth, ACCS, EFE)


Met --> SAM (AdoMet)

Met sam.jpg


Sam acc.jpg

ACC --> Ethylene

Acc eth.jpg

More to come soon!