Team:Baltimore US/Notebook/EPInstructions

From 2010.igem.org

Revision as of 16:43, 27 October 2010 by MPekala (Talk | contribs)
TitleBarBalti US.png
Home Team Official Team Profile Project Submitted Parts Modeling Notebook Meeting/Lab Times Safety


Building a cheap Electrophoresis

To construct the cheap electrophoresis that we have designed you need several parts. All of the components of the electrophoresis are laser cut acrylic of .220" thickness. The design can be modified to use any thickness that is around .220". If you do not possess your own laser cutter or do not have access to one, the parts can be laser cut using several online services such as Ponoko (http://www.ponoko.com/), Pololu (http://www.pololu.com/catalog/product/749), or any other laser cutting service. Note that this does increase the price of the electrophoresis as can be expected from any small quantity machine shop. The design files and list of materials are included at the bottom of this page.

Parts

The following parts are needed:


Construction

1. Get the two Holder sides and the base.
Build1.jpg
2. Glue the two Holder sides to the base using Plastruct Weld. Hold this together for five minutes.
Build2.jpg
3. If needed, brush more Plastruct weld into the cracks to ensure a seal. Hold this together.
Build3.jpg
4. Get the long sides and the previously constructed holder.
Build4.jpg
5. Glue the long sides to the previously constructed holder using Plastruct Weld. If needed brush more in the cracks.
Build5.jpg
6. Wait 24 hours for the Plastruct to set.
7. Get the silicone caulk and the construct.
Build6.jpg
8. Caulk the construct on all of the inside seams.
Build7.jpg
9. Get the anode/cathode holders and conducting plates. Screw a plate onto the anode and cathode.
Build8.jpg


Finished Device

EP.jpg EP2.jpg


Design Files