Team:Aberdeen Scotland/Copper Dose Response of the CUP1 Promoter Using N4


Revision as of 11:56, 26 October 2010 by Porter (Talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

University of Aberdeen - ayeSwitch - iGEM 2010

Quantitative Determination of the Response of the CUP1p - [GFP] to Varying Concentration of CuSO4


The aim of this experiment is to characterise the CUP1 promoter present in CUP1p - [GFP] by determining whether it displays a dose response quality. The determined characteristics of this promoter can then be applied to the promoter present in CUP1p - [MS2-CFP] in order to allow more precise modelling of the switch.


The CUP1 promoter exhibits a linear relationship between the concentration of CuSO4 and the level of GFP expression when CuSO4 concentrations range from 0µM to 100µM. At concentrations of 100µM and higher the expression level of GFP will have reached a steady state and will remain unchanged despite increasing CuSO4 concentrations.


A genomically integrated GFP gene under control of a CUP1 promoter was used to characterise the control properties of this promoter. This construct is referred to as CUP1p-[GFP] and was transformed into the yeast strain BY4741 for analysis.
Three separate starter cultures were prepared of CUP1p-[GFP] in 5mL SD medium. The following tubes were then prepared in triplicate.

Each one of these tubes was inoculated with N4 from each stater culture in order to provide triplicates of each concentratuion value. The cells were later harvested once the OD600 had reached 0.6. Triplicates from each culture were then loaded onto a 96 microtitre plate. The fluorescence of each sample was measured using a fluorometer running the "RussGFP" protocol.


For full data spreadsheet
IGEM 240610 JH+SL PCup Induction.xslx


The data suggests evidence of a dose dependent response. We can see from Figure 1 that the relationship between the GFP levels and the copper concentrations is linear when the concentrations of CuSO4 range from 0µM to 75µM. At concentrations higher than 75µM the response seems to reach a plateau and the GFP levels no longer increase along with increasing copper concentrations. Figure 2 shows us that these characteristics appear for each individual culture.

The data supports the hypothesis that the response of the copper promoter is dose dependent for a defined range of copper concentrations. The data however indicates that this range is smaller than our initial hypothesis suggested and that a plateau is reached with concentrations of 75μM as opposed to the initial 100μM.


[1]. Gorman JA, Clark PE, Lee MC, Debouck C and Rosenberg M
Regulation of the yeast metallothionein gene
Gene, 48 (1986 13-22)

Back to the Top