Team:Stanford/Notebook/Lab Work/Week 6

Spring: Brainstorming | Spring Meetings

Summer: Week 1 | Week 2 | Week 3 | Week 4 | Week 5 | Week 6 | Week 7 | Week 8 | Week 9 | Week 10 | Summaries

8/2 Monday

Greg's Notebook

• Inoculated freezer stocks of most of our parts with Alex
• Began planning for promoter characterization project:
  • Going to do 3A ligations of the form: promoter + superfolded GFP + Kan plasmid
• Process:
  • • Digest parts with at least 2 ug DNA
    • PCR cleanup
    • Diagnostic gel (remember to save uncut DNA for control)
    • Ligate in PCR tubes
    • Heat inactivate at 65 C for 20 min
• Performed first digestion (F2620 + sfGFP + pSB4k5)

Part #	Part amount	BSA	NEB (#, amount)	Enzymes (1 uL each)	Water
F2620	10.8	3	2, 3	E + S	11.2
pSB4k5	20	3	3, 3	E + P	2
sfGFP	11.76	3	2, 3	X + P	10.24

• Let digestions run for 1 hour at 37 C
• Ran diagnostic gel:
  • sfGFP digested nicely, F2620 yielded 3 bands corresponding to insert, cut plasmid, and uncut plamid
  • pSB4k5 gave only one band and a smudge, so I decided to redigest with only .5 uL of each enzyme, leaving it to run overnight

Karina's Notebook

Goals: Laura and Francisco will miniprep pBad. I'll make 2% diagnostic gel to use for the day.

Gel
Recipe: 1 g agarose, 50 mL TAE, 5 uL EtBr
Order of Ladder: 1) RSID 1
2) RSID 2
3) sRNA 1
4) 100 bp ladder
5) sRNA 2
6) sRNA 1C
7) sRNA 2C
8) 1 kb ladder
9) miniprepped pBad

Francisco has image of gel.

• can't see PCR product. Will load 5 uL of sample + 1 uL dye and run again.
  
  

Help Chris
Chris is making electrocompetent cells. Helped him get OD readings.

Sample	Reading 1	Reading 2	Reading 3
BW	.25	.40	.97
DH10B #1	.38	.53	.60
DH10B #2	.34	.47	.55

PCR Cleanup
Cleaned up PCR products using MinElute PCR purification kit. Protocol found [http://biotech.wku.edu/online_manual/MinElute%20PCR%20Purification%20Kit.pdf here].

8/3 Tuesday

Greg's Notebook

• Ran diagnostic gel of overnight pSB4k5 digest
  • Still didn't work; there were 3 bands, the smallest of which was about the size of the plasmid backbone, and there was no band corresponding to the ccdB insert
• Decided to re-redigest pSB4k5 using .5 uL of each enzyme for only 1 hour
  • After running on a diagnostic gel, discovered that this, too, failed in the same way as the previous digestions had. I decided to try other Kan plasmids
• PCR'd Chris's transcription factor promoter (pTFc)
• Ran nanodrop of pTFc and yesterday's sfGFP and F2620:

Part #	230	280	Concentration
pTFc A	1.36	1.79	196.1
pTFc B	2.08	1.86	159.7
sfGFP	1.89	1.87	52.9
F2620	1.82	1.82	35.5

8/4 Wednesday

Greg's Notebook

• Performed restriction digest of pTFc, J23100, J23106, J23109, F2620, pSB2k3, pBAD*, pSB1k3
  • *There wasn't enough pBAD, so I used all that was left (~20uL). Even if this digest fails I still have the previously-digested stuff at a low-ish concentration

Laura's Notebook

NanoDrop data for Alex's miniprep samples:

	260/280	260/230	ng/uL
I13500	1.82	1.31	221.7
J23106	1.85	1.42	187.6
J23109	1.88	1.47 210.5

Suggestions from Christina:

• diagnostic gels from yesterday's digestions (done by Francisco)

run promoters (pBAD, pLUX) on 0.8%, RSID's (1 and 2) and sRNA's (1, 2, 1C, 2C) on 2%

gel extract everything (on separate gels), depending on how complete digestions look- if PCR cleanup, SIP treat

• PCR cleanup inserts (PCR assembled parts)

use MiniElute columns use 10 mM Tris instead of H2O (water here is acidic, and elution is pH-dependant)

let sit 1 minute before eluting

load 1 uL on diagnostic gel

• check enzymes to see if getting low: order more if necessary
• colony PCR

primers: complementary to prefix and suffix or VF and VR? (VF and VR- further from ends to allow subsequent sequencing)

• • expected lengths with and without insert: ladder choice, gel %, extension time

10 uL reactions, run 5 uL on gel

setting up reactions:

• • make, aliquot master mix (SuperMix + primers)
  • pick colony with innoculating needle: inoculate PCR reaction, then streak on small square or wedge on a plate (make sure plates are dry)
  • screen (PCR) 5 colonies to start, but streak out 10-15 extras just in case/for further screenings

if no bands on gel, could be: not enough cells, not correct plasmid

if positive results, get sequenced

Plan for Colony PCR:

• primers: VR (~175bases from insertion site), VF (~140 bases from insertion site)
• insert lengths: GFP ~720 bp, RFP ~ 680 bp
• expected lengths on gel: without insert- 355 bp, with GFP- 1075 bp, with RFP- 1035 bp
• include positive control for PCR (from Chris- PCR reaction that has worked with this PCR mix)

Set up Colony PCR reactions (with Francisco): 0.5 uL each primer (VF and VR stocks from Alex) 9 uL PCR SuperMix

• enough for 11 reactions made, aliquot 10 uL to each of 10 PCR tubes
• pick 5 colonies each GFP-term and RFP-term- inoculate PCR reaction, then spread on small square of Kanamycin plate
• 15 extra colonies of each spread on plates

8/5 Thursday

Laura's Notebook

• 8:45am: put Chris' liquid cultures (8) in 4oC
• helped Greg with minipreps

10:00 am: meeting with Saum (IISME peer coach)

10:45 am: check in meeting with team- discussed plan for today (me: pour 2% gel, run colony PCR reactions from yesterday)

11:00 am: RET interview meeting (IISME stipend grant requirement)

• did gel purification with Francisco of pBAD, pLUX (I did pLUX, he did pBAD)

2% gel for colony PCR diagnostic- 95V, 30 minutes

• Francisco loaded other samples in top wells (PCR cleanup products, gel purification products from pBAD and pLUX)
  • order of top wells: RSID1, RSID2, sRNA1, 100 bp ladder, sRNA2, sRNA1C, sRNA2C, 100 bp ladder, pBAD, pLUX
• order (lower wells): GFP-term 1-5 (5uL of 10uL PCR rxns from yesterday + 1 uL loading dye), 100 bp ladder, 1kb ladder, RFP-term 1-5

3:35 pm: off to IISME End of Summer Celebration...

Karina's Notebook

Goal: Run PCR cleanup of RSIDs and sRNAs. Use minElute columns (Check to see if we have them). If not, run the clean up and concentrate down to 20 uL using Speed Vac. Elute in 50 uL Tris-HCl.

MinElute columns have purple "lining" of filter, NOT white, and are stored in the 4ºC.
Don't have any, so run clean up and then use Speed Vac to concentrate.
DON'T MIX UP BUFFERS.
Digestion volume: 50 uL
Let Tris-HCl stand for 1 min before spin

Dreamweaver Workshop!
Left lab from 1:00-4:30 to learn how to update the website.

8/6 Friday

Laura's Notebook

Worked with Francisco to plan, set up ligations- From yesterday's gel, these were my approximate concentrations (3 uL loaded each lane, so band ng divided by 3 for ng/uL):

• RSID1: 100 ng/uL
• RSID2: 130 ng/uL
• sRNA1: 13 ng/uL
• sRNA2: 17 ng/uL
• sRNA1C: 23 ng/uL
• sRNA2C: 23 ng/uL
• pBAD: barely visible- will redo miniprep, digestion, etc. before ligating
• pLUX: 20 ng/uL

Ligation Recipes:

	pLUX-RSID2	pLUX-sRNA1	pLUX-sRNA1C
H2O (uL)	7.0	1.0	4.0
vector: pLUX (uL)	8.0	8.0	8.0
insert (uL)	2.0	8.0	5.0
10X ligase buffer (uL)	2.0	2.0	2.0
T4 ligase (uL)	1.0	1.0	1.0

• 2 hours at room temperature
• transformed 0.5 uL of each ligation into 20 uL of DH10B electrocompetent cells