From 2010.igem.org

In order to optimise the lab work, we split up the work so that we could have two lab teams working in parallel to design different parts of the switch. We split up the lab work so we had:

Team 1: The Repressor-AntiRepressor Team
Team 2: The Terminator-AntiTerminator Team

The Repressor (Repressor-AntiRepressor) Team is responsible for assembling the construct illustrated below in Figure 1:

The AntiTerminator (Terminator-AntiTerminator) Team is responsible for assembling the construct illustrated in Figure 2:

Repressor Group

The repressor group will be assembling the constructs step-by-step:

Step 1

The construction of a plasmid containing the divergent promoters is the first step, the effect of this will be the uninhibited expression of GFP as illustrated by the green colonies observed in Figure 4.

Figure 3: The initial plasmid constructed is illustrated. The divergent promoters have been inserted into a plasmid and transformed into the electro-competent E.coli cells.

Figure 3: The success of the plasmid construction and transformation is illustrated by the fluorescent green colonies seen on the LB-agar plates.

Step 2

Figure 4: The construction of a plasmid containing the Repressor protein (GogR or GtgR) expressed from the pRM promoter is shown. The continually expressed repressor protein will then inhibit the pR promoter and no GFP will be expressed.

Team:DTU-Denmark/BBrick Characterisation

From 2010.igem.org

Introduction

Repressor Group

Step 1

Step 2