Team:Kyoto/Project/Goal C

Goal C: Characterization of the anti-killer gene

Introduction

As long as we know, there are two anti-killer genes　against the killer gene(lysis cassette), S107 and SΔTMD1. S107 is expressed by S gene encoded by lysis cassette and SΔTMD1 is an S allele with the transmembrane domein 1(TMD1) deleted. Because TMD1 of S gene is essential for the function of lysis cassette as killer gene, SΔTMD1 inhibits lysis cassette more strongly than S107.(Learn more) So, we selected SΔTMD1 as anti-killer gene.

Then, we checked if SΔTMD1 prevents lysis cassette from causing the cell death. To investigate the function of S&DELTA;TMD1, we used the E.coli transformed with both killer and anti-killer genes ( <partinfo>BBa_K358021</partinfo>). Because E.coli will be killed immediately if the killer-gene is constitutively expressed, we constructed the lysis cassette regulated by lac promoter. At first, the E.coli bacteria were grown in the medium without IPTG. After the enough population of E.coli, they were cultured in the one with IPTG to express lysis cassette. After that, we checked the growth rate of E.coli by measuring the absorbance (OD 550) of the growth medium. Thus, we investigated the possibility whether E.coli that contains both the killer and anti-killer genes could alive due to the constitutive expression of S&DELTA;TMD1.

Method

Bacterial strains

We used four types of E. coli as follows: (1) E. coli KRX transformed with <partinfo>BBa_K358021</partinfo>, (2)KRX transformed with <partinfo>BBa_K358022</partinfo>, (3)KRX transformed with <partinfo>BBa_K358024</partinfo> and (4)KRX transfomed with <partinfo>BBa_K358019</partinfo>. After this, we call each E.coli to abbreviate in order of name, LB2-1, lacLΔ, LB2-2 and lacL.

Construct

• <partinfo>BBa_K358021</partinfo>:Anti-killergene is induced constitutively and killergene is regulated by lactose promoter.

It was used in experiment 2.

• <partinfo>BBa_K358022</partinfo>:lacP + S&DELTA;TMD1RRz, TMD1 is deleted from lysis cassette[SRRz].

It was used in experiment 1.

• <partinfo>BBa_K358024</partinfo>: This part is the same to BBa_K358021, except for its constitutive promoter[BBa_J23101]. This part also induces constitutively S&DELTA;TMD1 gene, the anti-killer gene, and lambda lysis cassette[SRRz], the killer gene, is regulated by lacP.

It was used in the additional experiment, which is not finished.

• <partinfo>BBa_K358019</partinfo>: Lysis cassette regulated by lacP, Lysis cassette[SRRz] is regulated by lactose promoter.

Activating lactose promoter and expressing SRRz gene, it causes the cell lysis. Thus, lactose promoter must be repressed when this part is transformed. It was used in experiment 1 and 2.

Mesurement

Experiment 1

We pick up three colonies from each plate, and cultivate them in the supplemented M9 medium for a night, overnight. The overnight cultures were diluted to 0.1~0.11mM in pre-warmed fresh the supplemented M9 medium. 18h later, we measure OD 550 of the culture containing 0mM or 1mM IPTG.

Experiment 2

We pick up three colonies from each plate, and cultivate them in the supplemented M9 medium ~24-30 h (overnight).. The overnight cultures were diluted to 0.1~0.11 in pre-warmed fresh the supplemented M9 medium. we measure OD 550 of the culture containing various IPTG at about 100 minute interval.

Result

Experiment 1:Check the role of TMD1 of S gene

Fig.1.the comparion between lacL and lacLΔ.The black lines on bars' edges are error bar.

Then, in order to check if TMD1 of S gene is essential for this killer gene, we measured the cell number of lacLΔ, which does not have TMD1 of S gene and that is, encodes SΔTMD1 and that of lysis cassette. This result is below(Fig.1). From this result, after IPTG was added,the number of lacLΔ is not decreasing, while the number of lacLΔ is decresing. It proved that SΔTMD1 cannot function as killer gene and TMD1 is essential for this killer gene, lysis cassette. In addition, in the medium without IPTG, the number of lacLΔ is larger than that of lacLΔ.This supports a report ^[1]. which says that more proteins which is short are expressed than the ones which is long.

Experiment 2: Function check of SΔTMD1

We measured the cell number of lacLΔ at several time after induction by adding several concentration IPTG. The result is below (Fig.2). This result showed that in the medium with more than 0.03mM IPTG, the number of E. coli is decreasing at a certain point. It demonstrated that In at least more than 0.03mM IPTG, SΔTMD1 can't inhibit lysis cassette completly. Then, we measured the cell number of lacL in the same way, and compared the result of lacLΔ with that of lacL to check how SΔTMD1 inhibited lysis cassette(Fig.2). From this result, we knew in more than 0.5mM IPTG both Lacs and CTLA were decreasing in the number at a certain point, or CTLA was a little delayed decreaing in the number. This demonstrated that SΔTMD1 can't correctly inhibit lysis cassette. So, we doubted whether SΔTMD1 really functioned as anti-killer gene. Although SΔTMD1 has no TMD1 of S gene, SΔTMD1 couldn't show the function as anti-killer gene.

Fig.2.the result of function check of SΔTMD1. We measure OD 550 changing IPTG concentration, 0, 0.02, 0.03, 0.05, 0.3, 0.5, 0.7, 1.0 (mM).

Fig.3.Comparison between lacL and LB2-1. We compared at IPTG concentration 0, 0.02, 0.03, 0.5, 1.0.

Discussion

TMD1 of S gene is essential for lysis cassette

The result of experiment 1 supports Ref.1. That is, we were able to make sure that TMD1 of S gene is essential for lysis cassette as killer gene.

SΔTMD1 cannot inhibit lysis cassette completly

These results showed that SΔTMD1 cannot inhibit completely lysis cassette. This results can't supported a report on lysis ^[1]. which says that SΔTMD1 without TMD1 dominant-negatively inhibit lysis cassette. Why did we get the result against that report? Probably, there were three reasons below, we thought.

• SΔTMD1 in the plasmid did not worked correctly.
• S&DeltaTMD1 is weaker anti-killer gene than we expected.
• less SΔTMD1 proteins or more lysis cassette proteins was expressed than we expected.

Reason1:SΔTMD1 in the plasmid did not work correctly.

To investigate this reason, we sequenced BBa_K358021 we used. The result showed that this construct is inserted into the plasmid correctly, which demonstrated that SΔTMD1 worked correctly. So, we assume that the first reason is negative.

Reason2:SΔTMD1 is weaker anti-killer gene than we expected.

As anti-killer gene against lysis cassette, there are two genes, S107 and SΔTMD1(Learn more). S107 is the anti-killer gene. Because it has essential TMD1 of S for function of this killer gene, the anti-killer function of this gene is weak compared with SΔTMD1, which does not have TMD1(Learn more). Thus, we expected that SΔTMD1 is a strong anti-killer gene. However, from the result of experiment 2, we could not observe the function of SΔTMD1 as a strong anti-killer gene under the tested condition.

Reason3: Expression balance between the anti-killer and killer genes was not optimized properly.

In order to investigate the possibility of this reason, we analyzed the expression level of the killer gene, lysis cassette and SΔTMD1. As a report ^[2] says, it is necessary for the inhibition of lysis cassette that there are at least ~4.7 times more S107, anti-killer gene than lysis cassette proteins. So, Inhibition of this killer gene needs at least ~4.7 times more expression of the anti-killer gene than that of the killer gene. Thus, we calculated the ratio of the expression levels of the killer- and anti-killer- gene. The calculation was done under the assumptions　that S gene, which lysis cassette includes, produces S105 and S107 at a 2.5:1 ratio(Learn more), and that the strength of function of SΔTMD1 as anti-killer gene is the same as that of S107. By this calculation, we knew that in LB-1, the anti-killer gene couldn't inhibit killer gene in the medium with more than 0.1246 mM IPTG. So, we assume that SΔTMD1 was not expressed adequately to inhibit lysis cassette completly. We assume that our experimental results could be due to the 3rd reason (Reason 3) mentioned above, although we can not rule out the possibility of the second reason. However, it has been reported ^[1] that SΔTMD1 inhibits lysis cassette effectively. So, it is reasonable to assume that SΔTMD1 exhibits enough activity to inhibit lysis cassette. That is why we think that the Reason 3 is most likely the answer. To confirm this possibility, we changed the promoter of SΔTMD1 to stronger one. The experiment to check the function of SΔTMD1 using the strong promoter is currently underway. Surely, this result will help us to understand why SΔTMD1 could not function as we expected and to develop distinct cell-death controllable devices for the further studies.

Conclusion

1)We made SΔTMD1 by deleting TMD1 from S gene and registed it<partinfo>BBa_K358012</partinfo> and lysis cassetteΔTMD1(SΔTMD1RRz)<partinfo>BBa_K358014</partinfo> in BioBrick as new parts.

2)By the comparison of the function as killer gene between lysis cassette and lysis cassetteΔTMD1, We made sure that TMD1 is essential for fuction of lysis cassette as killer gene.

3)By co-expressing lysis cassette regulated by a lactose promoter, we characterized the function of SΔTMD1 as anti-killer gene.

Reference

1. Rebecca White, Tram Anh T. Tran, Chelsey A. Dankenbring, John Deaton, and Ry Young.2010.The N-Terminal Transmembrane Domain of _ S Is Required for Holin but Not Antiholin Function_. J. Bacteriol. 192: 725–733
2. CHUNG-YU CHANG, KIEBANG NAM, AND RY YOUNG1. 1995.2 S Gene Expression and the Timing of Lysis by Bacteriophage λ. J. Bacteriol. 177: 3283–3294