Team:UNIPV-Pavia/Material Methods/Measurements/Tecan/test28settembre

From 2010.igem.org

(Difference between revisions)

Revision as of 19:20, 27 October 2010

SEPTEMBER, 28TH

PLATE

EXPERIMENT DESCRIPTION

Motivation

This experiment was performed to check bacterial growth and GFP synthesis rate of the following constructs in order to verify right protein folding and efficiency of inducible system assembled upstream of some genetic circuits.

Methods

Inoculum (into 5 ml LB+Amp) from glycerol stock of:

I63
I64
I65
<partinfo>BBa_K173000</partinfo> (positive control)
<partinfo>BBa_B0031</partinfo> (negative control)

They were let grow ON at +37°C, 220 rpm.

The following day cultures were diluted 1:100 and let grow again for about five hours at +37°C, 220 rpm.

Optical density (O.D.) of each cell culture was than measured with TECAN Infinte F200. Samples were diluted in order to obtain the same O.D. equal to 0,02.

Than we performed a 21 hours' experiment with measurements of absorbance and green fluorescence every five minutes with TECAN Infinite F200. I63 and I64 circuits were also induced 100nM with HSL directly into multiplate well. Each value shown is the mean of three measurements, from GFP data that of a non-fluorescent culture (negative control) was subtracted; cultures were shaken for 15 seconds every five minutes.

RESULTS

Raw growth curve

Culture	Doubling time [min.] ± std error
<partinfo>BBa_K173000</partinfo>	76.3336 ± 1.4362
I63 induced	121.1434 ± 7.0275
I63 not induced	74.4267 ± 1.3696
I64 induced	122.6088 ± 1.2785
I64 not induced	71.5105 ± 2.7113
I65	78.4634 ± 2.5622
<partinfo>BBa_B0031</partinfo>	70.8421 ± 2.2181

Raw GFP curve

Mean of (dGFP/dt)/O.D.600 (under the hypothesis that GFP half-life in fusion contructs is similar to the original one - <partinfo>BBa_E0040</partinfo>)

All cell cultures showed a similar growth curve and doubling time was computed as described here in order to have informations about the burden due to synthesis of such fusion proteins. It's possible to see that all doubling time are very similar except for induced cultures. In this case doubling time is much higher than posite control and not induced cultures; so it's possible to assert that in this case there's a kind of metabolic burden higher than in the others, maybe because of the inducible system.

From GFP curve it's possible to appreciate that in induced I63, I64 and I65 GFP accumulation profile it's very similar and it's significantly different from that of negative control <partinfo>BBa_B0031</partinfo>. On the other hand not induced I63 and I64 show a profile very similar to the last one. This result that the green fluorescent protein assembled downstream of the genetic circuit is correctly folded.

The mean protein synthesis rate was also computed over the growth exponential phase, showing again an appreciable GFP production rate for I65 and a lower one for inducible constructs. Also not induced I63 and I64 show a low GFP synthesis rate maybe due to 3OC6HSL inducible circuit leakage activity.

Tecan Test

@@ Line 73: / Line 73: @@
 All cell cultures showed a similar growth curve and doubling time was computed as described [[Team:UNIPV-Pavia/Parts/Characterization#Doubling_time_evaluation|here]] in order to have informations about the burden due to synthesis of such fusion proteins. It's possible to see that all doubling time are very similar except for induced cultures. In this case doubling time is much higher than posite control and not induced cultures; so it's possible to assert that in this case there's a kind of metabolic burden higher than in the others, maybe because of the inducible system.
-In GFP curve it's possible to appreciate that in induced I63, I64 and I65 GFP accumulation profile it's very similar and it's significantly different from that of negative control <partinfo>BBa_B0031</partinfo>. On the other hand not induced I63 and I64 show a profile very similar to the last one. These results show the right folding of the green fluorescent protein assembled downstream of the genetic circuit and that the inducible system works as expected.
+From GFP curve it's possible to appreciate that in induced I63, I64 and I65 GFP accumulation profile it's very similar and it's significantly different from that of negative control <partinfo>BBa_B0031</partinfo>. On the other hand not induced I63 and I64 show a profile very similar to the last one. This result that the green fluorescent protein assembled downstream of the genetic circuit is correctly folded.
 The mean protein synthesis rate was also computed over the growth exponential phase, showing again an appreciable GFP production rate for I65 and a lower one for inducible constructs. Also not induced I63 and I64 show a low GFP synthesis rate maybe due to 3OC6HSL inducible circuit leakage activity.