Team:UPO-Sevilla/Project/Assays

From 2010.igem.org

Revision as of 00:22, 26 October 2010 by Paola (Talk | contribs)

Introduction

Motility is one of the most readily demonstrated bacterial characters, and chemotaxis is one of the most studied bacterial behaviors. Motile organisms are attracted by certain chemicals and repelled by others (positive and negative chemotaxis). Quantification of chemotactic motion is necessary to identify chemoeffectors and to determine the structure of bacterial communities.

Current methods of quantifying chemotaxis use chemotactic bacteria such as Escherichia Coli, which is assayed by measuring the number of organisms attracted into a capillary tube containing an attractant.

UPO-Sevilla team has carried out different experimental prototypes which try to have under control all the parameters involved in chemotaxis. The goal of the group was designing different assays that allow us to study this effect in both point of views, qualitative and quantitative. Also we had to test induction of sensing systems and chemoattractant production. Anyway, these behaviours are highly related with the chemotaxis process in Bacterial Crowding project. This is why we have measured chemoattractant production by counting the range of attracted bacteria by using chemotaxis assays. The induction of sensing systems could be tested by using GFP measures when its promoter is PfecA or PprhJ; or also due to the levels of chemoattractant production.

Qualitative Assays

Agar Soft Plates

Our qualitative assays were made in soft agar thanks to the protocols that we had received from Ph.D Parkinson (University of Utah).

This kind of plates allows bacteria to swim trough the agar freely and showing their chemotactic capacities. A colony, inserted in soft agar plate, starts to grow while running out the environmental sources. For this reason bacteria would move to places where the sources are not limited. That phenomenon produces a number of halos which are spread within the plate and increase in volume as the sources are lowered.

Soft Agar Plate Assay

Fig 1. Soft agar plate assay. Different strains are shown. Every strain carries out a mutation that affects its chemotactic response, every strain but the wild type. In the wt you can observe two halos produced by chemotactic responses to aspartate and glutamate.

The assay protocol is simple; once the soft agar plates are prepared, a colony is inserted in the previous plate. Let it grow in 30ºC. The soft agar is a delicate element, so it is important to be careful when moving the plates.

In those plates it might appear different concentric circles which represent chemotaxis to a certain attractant. For instance, when two amino acids are run out from the medium, two circles will appear. The inner one will show the amino acids limit with low chemotactic response; while the outer one will mean that the amino acid which causes a higher response is running down.

Optical and Fluorescence Microscopy

The microscopy techniques allow us to see the development of the assay in situ without any wait. In this part we will see how we can carry out an experiment that we could see under the microscope.

Capillary assay yo look under a microscope

Fig 2. Preparation of capillary assay to look under a microscope.

Over a microscope slide two capillaries are put which will hold up a cover slip. Then we insert the bacterial dilution between the slide and the cover slip. Two new capillaries are inserted between the slide and the cover slip inside of the bacterial dilution. One of those capillaries will contain a chemoattractant while the other one will be the control. Under the microscope we can see the different between both capillaries and we will definitely be able to observe if there is chemotaxis toward this chemoattractant.

Apart from that, we can detect the fluorescence emitted by the fluorophore which is present in bacteria using a fluorescent microscope.

This assay can be quantitative too if we spread on agar plates the content of capillaries and count the number of colonies that grew there.

Capillary assay Pictures

Fig 3.Results of a capillary assay using microscope techniques. We can see that the chemotatic response toward aspartate is increasing as time passes by. Also there are major differences between the control without aspartate and the control with aspartate.

Quantitative Assays

Capillary assays

The capillary assays are the most useful to quantify chemotaxis. Although with some problems, this team has performed a capillary assay.

Capillary assay of E. coli chemotaxis toward aspartate

Fig 4. On the left, a capillary assay with 96-well PVC microplates and 1μl capillary pipettes; capillaries are inserted through a 2% agarose gel. On the right, a capillary assay using needles and a tip chamber. Both of them were being incubated at 30oC when pictures was taken.

  • Foundations

    A capillary, which is put in a bacterial dilution, makes a concentration gradient of chemoatractant, produced by thr flow that goes from capillary to the medium according to the Fick law (see http://en.wikipedia.org/wiki/Fick's_laws_of_diffusion). This gradient would be sensed by bacteria that are going from low to high concentration places thus we should have some bacteria into the capillary. We can demonstrate that when we compare a capillary chemoattractant with another without any substance (the control), just the buffer. The control has to continue the same protocol than the others. In the same way the efficacy of a repellent could be tested since the capillary with the repellent will have less bacteria than the control.

    Bacterial dilution recipient or Chemotaxis Chambers Attractant or Buffer recipient or Capillaries
    tip chambers syringe’s needles (more or less thin)
    needle’s cups or heated closed 100ml tips Needles
    tip chambers 10μl micropipette’s tips
    96-well PVC microplates 1μl capillary pipettes
    drop between microscope slide and cover slip 1μl capillary pipettes
    Flow-chamber 1μl capillary pipettes

    Table 1. Several ways we have carried out using capillary methods in chemotaxis assays.

    This team has performed this assay in different scales using differents chemotactic chambers where the bacterial dilution was put inside and differents capillaries. Some types of that are reflected in the Table 1. The attractant concentration in the capillary depends on the substance itself.

    Another kind of capillary assay, that we had good results in, uses flow-chambers as chemotaxis chambers and 1μl capillary pipettes as capillaries. This method allows us quantify bacterial density in two different ways,visualization of flow-chambers by fluorescent microscope techniques and spreading in LB plates bacteria inside of capillary. Actually, using that way to quantify bacteria we make less errors; when we put a capillary into the chemotaxis chamber the fixing is perfect and the error in the dilutions are minimal.

  • Protocol

    Representation of capillary assay in a tip chambers.

    Fig 5.Representation of capillary assay in a tip chambers.

    The experiment may start in two different ways; putting inocula from the strains we are going to work with into triptone broth or in minimal medium in a low shaking at 30ºC overnight. A high shaking might provoke the loss of flagella. The production of flagella wouldn’t be possible in a rich medium since bacteria wouldn’t need it.

    The following day the inocula should be diluted in the same medium a hundred of times and wait for the growing phase to be the appropriate. For Escherichia Coli it would be necessary to wait for the exponential middle phase since it is this phase when flagella develop the flagellar motor. For Pseudomonas instead it would better wait for the late exponential phase, as the flagellum is developed later in this organism.

    Once the culture is ready, it must be changed in an appropriate medium for mobility and chemotaxis. For that, it is necessary to wash the culture twice with chemotaxis buffer centrifuging in a low speed since flagella may be lost if it is treated abruptly.

    When the culture is in the right medium the number of bacteria is adjusted roughly to 107 fcu/ml. This dilution has to be distributed in chemotaxis chambers where our capillaries will be introduced in it. The volume of capillaries can be unsettled; we have used as a standard volume 100 μl of diluted chemoattractant in chemotaxis buffer. Mind controls, they will be capillaries thanks to the chemotaxis buffer.

    Incubate the experiment at 30º during 60 minutes, after that we have to quantify bacteria that are contained into the capillaries. In order to achieve that we could do it either with dilution and spread in plates or analyzing the fluorescence, supposing that bacteria have any kind of fluorophore.

  • Advice

    One of the elements we bear in mind is the chemotaxis buffer: chemotaxis medium contain potassium potassium phospgate buffer (pH 7), ethylenediaminetetraacetate (EDTA) and glycerol (energy source). The glycerol is only necessary in long incubations; meanwhile in short incubations the typical sources of bacteria are enough to maintain the chemotactic machinery. It is all-important to underline that the chemotaxis medium must be free of any other substance which may have chemotactic effects, since this could disturb the results. This is one of the reasons why the carbon source is not glucose, how you may expect. Other important detail to bear in mind is EDTA, this chelation provoke the precipitation of magnesium which may dull the movement of bacteria and the flagellar machinery. It would be complicated to success in the chemotaxis assays without this chelation. Incubation of bacteria must be carried at 30ºC since it helps motility. Shaking must be low as flagella can be lost in high shaking.

    It is crucial to be careful when choosing the strains to be used in the chemotaxis assays, since it may not have motility. Strains used in laboratories have normally no motility, as at that point they have usually suffer different screening process in benefit of immobile bacteria. A bacterium which has no motility won’t have to invest in any source in motility or chemotaxis; this would encourage the creation of a colony bigger and more eye-catching than usual, so scientifics would be probably leaded to select one of this kind. . This issue happened to us and we were trying to attract a non mobile strain toward different attractants until we realised.

Buridan’s Donkey

To test bacterial chemotaxis we have used a three-channel device based on flow-chamber biofilm. It would be able to produce a linear gradient within narrow tubes that connect the chambers. The linear chemical gradient would be generated by diffusion of the chemoattractant through a dialysis membrane located in the limit of the chamber. This membrane also makes impossible the movement of the chemoattractant-producing bacteria through the tube.

The first assay involves only chemoattractants, and the second one includes producing bacterias. As result, it is expected that the movement of the cells in the center chamber was directed to the chamber containing chemoattractant-producing bacterias, for the cells chemotactic response, but not in the control chamber, in the opposite side. It is necessary to clear up that the chemoattractant production would be activated solely by the contact of bacteria with plant cell walls that reside in the same chamber. Bacteria have to “decide” between going toward control empty chamber or going toward chamber with chemoattractant-producing bacteria.

This device could provide a lot of advantages in the study of chemotaxis: rapid and easy implementation, parallel and simultaneous test, visual proofs, different assays possibilities. Also some experimental conditions could be changed easily, for instance: concentration of bacterial population, chambers distances, bacterial cultures, chemoattractans.

An explaining diagram of this device is provided below.

Measuring the performance of the chemotaxis circuits (Buridan's donkey assay principle)

Measuring the performance of the chemotaxis circuits (Buridan's donkey assay principle)

Buridan's donkey assays with three-channel flow cells

Buridan's donkey assays with three-channel flow cells

Special acknowledgements to Ph.D Parkinson (University of Utah) who gave us some advices, handed us over some protocols of him, even mobile and mutant E. Coli strains.

References

  • J. Adler (1972) A Method for Measuring Chemotaxis and Use of the Method to Determine Optimum Conditions for Chemotaxis by Escherichia coli. - Journal of General Microbiology ( I 973), 74, 77-91
  • Guocheng Han and Joseph J. Cooney (1993) A modified capillary assay for chemotaxis - Journal of Industrial Microbiology, 12 (1993) 396—398
  • Hanbin Mao, Paul S. Cremer, and Michael D. Manson (2003) A sensitive, versatile microfluidic assay for bacterial chemotaxis - PNAS MICROBIOLOGY vol. 100 no. 9 5449–5454.
  • Russell Bainer, Heungwon Park, Philippe Cluzel (2003) A high-throughput capillary assay for bacterial chemotaxis - Journal of Microbiological Methods 55 (2003) 315– 319.
Return to Project
Footer