Team:NYMU-Taipei/Experiments/Speedy degrader

From 2010.igem.org

(Difference between revisions)
(Method)
(Method)
Line 3: Line 3:
-
=Method =
+
=Method=
*Protocol:  
*Protocol:  
Line 24: Line 24:
 +
=Reporting Assay=
{{:Team:NYMU-Taipei/Footer}}
{{:Team:NYMU-Taipei/Footer}}

Revision as of 21:00, 27 October 2010



Method

  • Protocol:

1.Selected genes to be reported are incubated overnight in an LB liquid culture at 37oC and 180-200rpm. This makes sure they are fresh in the morning. Positive and negative controls are also needed.

2.The liquids cultured overnight are diluted into an OD600 of 1 and incubated for 2 hours.

3. After 2 hours, we took out the liquids and centrifuge them for 30 seconds at 13.2k rpm and then discard the supernatant. We then resuspended the pellets in ____ABT medium.

4.Take 200uL from the liquids to measure OD600, doing three replicates, noting down OD value as well.

5.Measurement of fluorescence: Continuous measurement of fluorescence with the excitation/emission wavelengths depending on different FP for one hour, with one fluorescence data point every 2 minutes.

6.After measuring the fluorescence, we recorded OD value again to confirm that the E. coli has stopped growing in the ABT medium.


  • The optimizing data:

Check if the ODs remained the same to make sure the E. coli does not grow in ABT medium. We took fluorescence averages for all the replicates and sketched a curve and fitted a trend line. Exponential curves were fitted and the half-life of the FP calculated. However, the actual data do not fit exponential curve quite well.


Reporting Assay