"

From 2010.igem.org

Revision as of 19:12, 17 October 2010 (view source) Langmo (Talk | contribs) (→Details on microscope) ← Older edit		Revision as of 19:13, 17 October 2010 (view source) Langmo (Talk | contribs) (→Details on the Flow Channel) Newer edit →
Line 10:		Line 10:
	{| border="0" align="center"		{| border="0" align="center"
	|- valign="top"		|- valign="top"
-	|[[Image:channel1.jpg|thumb|200px|The mold for the channel.]]	+	|[[Image:channel1.jpg|thumb|200px|Figure 2: The mold for the channel. Has to be cleaned after casting.]]
-	|[[Image:channel2.jpg|thumb|200px|The casted raw channel with a cover slip and the razor plate needed for preparing the channel.]]	+	|[[Image:channel2.jpg|thumb|200px|Figure 3: The casted raw channel with a cover slip and the razor plate needed for preparing the channel.]]
-	|[[Image:channel3.jpg|thumb|200px|The assembled channel, yet not bonded.]]	+	|[[Image:channel3.jpg|thumb|200px|Figure 4: The assembled channel, yet not bonded.]]
	|- valign="top"		|- valign="top"
-	|[[Image:channel4.jpg|thumb|200px|Bonding the channel.]]	+	|[[Image:channel4.jpg|thumb|200px|Figure 5: Bonding the channel.]]
-	|[[Image:channel5.jpg|thumb|200px|The ready to use channel under the microscope.]]	+	|[[Image:channel5.jpg|thumb|200px|Figure 6: The ready to use channel under the microscope.]]
	|}		|}

---

Revision as of 19:13, 17 October 2010

Microscopy

Details on microscope

A microscope with motorized x, y and z control, a motorized shutter and a 60× lens is used with appropriate fluorescence filters for the fluorescence signals. Light-emitting diode arrays are installed as light sources for red light (660 nm) and far-red light (748 nm) pulses.

Details on the Flow Channel

Figure 2: The mold for the channel. Has to be cleaned after casting.	Figure 3: The casted raw channel with a cover slip and the razor plate needed for preparing the channel.	Figure 4: The assembled channel, yet not bonded.
Figure 5: Bonding the channel.	Figure 6: The ready to use channel under the microscope.

Details on the red light/ far-red light diodes and the filters

The mold for the channel.

The casted raw channel with a cover slip and the razor plate needed for preparing the channel.

The assembled channel, yet not bonded.